In general, the bearing can be used only when it is matched with the shaft and bearing seat. Do you know how to use the bearing interference fit assembly? Some people will ask: “interference fit assembly does not mean that the shaft or sleeve parts are installed into the hole, is the size of the… Read more Why do bearings adopt interference fit assembly?
Tag: interference fit assembly
Deficiency of hot assembly technology in equipment maintenance
In the process of equipment maintenance, there are often transitions and interference fit assembly of copper sleeve, steel sleeve, bearing, shaft and gear. In the past, the assembly process used to be mostly hot assembly (hot assembly for short), that is to say, by means of flame heating or oil boiling heating, the parts were… Read more Deficiency of hot assembly technology in equipment maintenance
Assembly of interference fit parts
The interference fit assembly of mechanical parts is widely used in practice. Reasonable preparation of interference is an important condition to ensure the normal and reliable operation of mechanical parts and to extend the service life of parts. 1 precautions in design of interference fit partsa. The minimum actual interference after assembly can ensure the… Read more Assembly of interference fit parts